#LOGITECH ALERT COMMANDER OPENHAB HOW TO#
#LOGITECH ALERT COMMANDER OPENHAB SERIAL#
#LOGITECH ALERT COMMANDER OPENHAB MANUAL#

It is used by various stove manufacturers like Laminox, Extraflame, Evacalor, Dalzotto, Ungaro, Arcestufe, Karmek, Tecnoflam, Termoflam, Clam, Cadel, Zibro, Sicalor, Kepo, EcoTeck and many others. By google searching pellet stove controllers I noticed that mine looks very similarly as those made by Micronova so it was clear – the controller inside my stove is some board from Micronova (i023, i050 or who knows). So I needed a way to control it remotely. Problem is that sometimes I am outside and I want to turn on the stove remotely so that when I arrive, it will be warm inside. It is a nice thing to have over the winter. They installed a Laminox pellet stove in our house.

#LOGITECH ALERT COMMANDER OPENHAB HOW TO#

Note: Devices might not respond or return an error to some command when the device is powered off which will make your items look in a wrong state until the TV turns on.įor instance, getting the volume status when the device is off makes no sense.Here is how to control a pellet stove with a Micronova controller remotely either via IR commands or using the serial line. If your device documentation doesn't give such information, you can look at the 'LG protocol references' below and use the 'Generic LG TV' thing which should contain all the different possible channels/commands.

Sets the volume, values are from 0 to 100Īs for others, please refer to the documentation of your device in the section named 'Controlling the multiple product', 'External control' or any section that refers to RS-232, the names of the channels map the command names. Channel type idĪdjust screen format, at least 4:3, 16:9 formats

#LOGITECH ALERT COMMANDER OPENHAB SERIAL#

The following channels are common to most TV through the serial or service port, taken from. However, the item values for the thing with set id 0 will never display the right values as it receives responses from many devices. That allows you to have a thing that will handle a particular device (with set id other than 0), and another to send command on all devices (with set id equals 0). The set id can also be specified when using daisy-chaining. On Linux systems, this will usually be either /dev/ttyS0, /dev/ttyUSB0 or /dev/ttyACM0 (or a higher number than 0 if multiple devices are present). It is necessary to specify the serial port device used for communication.

#LOGITECH ALERT COMMANDER OPENHAB MANUAL#

No discovery supported, manual configuration is required.

LG 47LK520 with a serial hat (opens new window) on a Raspberry Pi.

LG 55UF772V (with this cable adapter (opens new window)).

The serial port may be marked 'Service only'. Some TVs may have an alternative port type instead of a standard DB9 connector, and may thus require an adapter.

The LG serial command set appears to be similar on many models (, ), but not all commands will work on all models. The protocol supports daisy-chaining of serial devices. Supports one TV or projector per thing, also corresponding to a unique serial port. See below for a list of supported channels. This binding can send some commands typically used by LG LCD TVs (and some used by projectors).

Logitech alert commander openhab